Renault Master Van 2004 - Page 53

Display 1
2 General reset and trip mileage
recorder reset button
To reset the trip mileage recorder,
the display must show the Trip
mileometer function.
1.48
Display selection key 3
Keep pressing key 3 briefly to scroll
through the following information
in sequence:
a) total mileage recorder,
b) trip mileage recorder,
c) fuel used,
d) average consumption,
e) current consumption,
f) estimated range,
g) distance covered,
bh) average speed;
i) governed speed (speed limiter/
cruise control).
Refer to the table on the following
page for display examples.
Interpreting values displayed
after resetting:
The values showing average fuel
consumption, range and average
speed will become more stable and
reliable the further you travel since
the last time the reset key was
pressed.
For the first few miles after pre
the reset key you may noti
¢ that the range incr
travel. This is normal.
fuel consumption may dec
when:
- the vehicle stops accelerat
- the engine reaches its op g
temperature (engine cold when
reset button pressed),
- when driving from a built-up
area onto the open road.
Therefore, if the average fuel
consumption decreases, the range
will increase.
* You may also notice that the
average fuel consumption
increases when the vehicle is
stationary and the engine idling.
This is normal since the computer
takes account of fuel used during
idling.
Note: resetting is automatic when
the maximum capacity of any of the
memories is exceeded.