WIPER BLADES: REPLACEMENT
6
342 - Practical advice
Replacing the windscreen wiper
blades 2
To replace the wipers, first put them in
the service position
B
.
Engine running or ignition on:
– move the stalk
1
twice in succession
to position
A
(single sweep): the wiper
blades will stop in the service position
B
away from the bonnet;
– lift the wiper arm
3
;
– lower the tab
4
and remove the
blade
2
.
Refitting
To refit the wiper blade
2
, insert it into
its housing in the arm
3
,thenclipitun
til you hear a click. Make sure that the
blade is correctly locked in position.
Toreturnthebladestotheloweredpo
sition, make sure that the blades are
folded down onto the windscreen then
set the stalk
1
to position
A
(single
sweep): the windscreen wiper blades
willfoldintothebonnetwhentheigni
tion is switched on.
Check the condition of the
wiperblades.Youarere
sponsible for their service
life:
– clean the blades, windscreen
and rear screen regularly with
soapy water;
– donotusethemwhenthewind
screen or rear screen is dry;
– free them from the windscreen
or rear screen when they have
not been used for a long time.