Renault SYMBIOZ 2024 - Rear Bench Seat: Functions

REAR SEATS
2
Getting to know your vehicle - 53
Rear bench seat: functions
To fold down the seatback
Ensure that the front seats are far
enough forward.
Before folding down a seatback:
– lower the headrests fully;
– place the seat belt in the belt guide
A andbuckletheseatbelt.Thispre
vents the seat belt from locking when
the seatback is lifted up again.
Pull the handle 1 andlowertheseat
back B .
Note: for safety reasons, the seatback
B is equipped with a retaining system.
You may experience resistance when
handling.
To replace the seatback, proceed in
the reverse order to removal.
Raisetheseatbackagainuntilitreach
es the locking joint of the seatback.
Be careful not to jam the safety strap
between the backrest and the parcel
shelf.
Check the operation of the seat belt.
Beforemovingtheseat
back, put seat belt in belt
guide A to avoid damaging
it.
When refitting the seat
back, make sure it is
correctly locked in place.
If seat covers are fit
ted,makesurethesedonotpre
venttheseatbacklatchfromlock
ing in.
Make sure that the seat belts are
positioned correctly.
Reposition the headrests.
Tomoveaseatforwardsorback
wards
Raise the lever 2 from the rear seats
to unlock the bench seat.
Move the seat forwards or back to the
required position.
Release the lever 2 and ensure that
the bench seat is properly locked.
For safety reasons, carry
out any adjustments
whilethevehicleissta
tionary.