WHEEL TRIM, TOOLS
6
Practical advice - 137
|
lease knob
6
. Swing out the lever
7
and take out the jack
2
. To store the
jack after use, ensure the jack is locat-
ed in the same position, swing out the
lever
7
again and tighten the knob
6
.
Wheel wrench
3
This can be used to lock or unlock the
wheel bolts and the towing eye
5
.
This is placed along with warning trian-
gle. Replace it in the same pouch after
use.
Guide wheel bolt
4
Towing eye
5
🡺 160
Do not leave the tools
unsecured inside the ve-
hicle as they may be
projected during braking.
After use, check that all the tools
are correctly clipped into the tool
kit, then position it correctly in its
housing to reduce any risk of in-
jury.
If bolts are supplied with the
emergency spare wheel, you
must use these bolts only for the
emergency spare wheel.
For safety reasons, the
use of a jack not recom-
mended by the manufac-
turer is strictly forbidden.
The jack is specific to the vehicle
and used to change the wheels.
Under no circumstances should it
be used:
– on another vehicle;
– to carry out a repair;
– to access the underside of the
vehicle.
Risk of injury.
Risk of damage to the vehicle.
To Next Page
Loading...
