Renault WIND - Gear Lever; Handbrake

gear lever...............................................................(current page)
changing gear .......................................(up to the end of the DU)
reverse gear
selecting ..........................................(up to the end of the DU)
driving ...................................................(up to the end of the DU)
handbrake.............................................(up to the end of the DU)
2.5
ENG_UD24356_2
Levier de vitesses (E33 - X33 - Renault)ENG_NU_865-5_E33_Renault_2
Gearstick
Handbrake
GEAR LEVER/HANDBRAKE
Gear lever
Selecting reverse gear
With the vehicle stationary, move the
gear lever into neutral then into reverse.
Follow the grid shown on knob 1.
The reversing lights will come on as
soon as reverse gear is selected (with
the ignition on).
1
Handbrake
To release:
Pull lever 2 up slightly, press button 3
and then lower the lever to the floor.
To apply:
Pull the lever 2 upwards and make sure
the vehicle is immobilised.
Depending on the gradient
and/or vehicle load, it may
be necessary when station-
ary to apply the brake by
at least a further two notches and
engage a gear (1
st
or reverse gear).
Make sure that the hand-
brake is properly released
when driving (red indicator
light off), otherwise over-
heating may occur.
An impact to the underside
of the vehicle when revers-
ing (e.g. striking a raised
kerb) may result in damage
to the vehicle (eg. deformation of
the rear axle).
To avoid any risk of accident, have
your vehicle checked by an ap-
proved Dealer.
3
2
1