Need help?Do you have a question about the Renegade RXA 550 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Frequency Response | 10 Hz - 30 kHz |
| THD | < 0.05% |
| Signal-to-Noise Ratio | > 90dB |
| Low Pass Filter | 50 Hz - 250 Hz |
| High Pass Filter | 50 Hz - 250 Hz |
| Bass Boost | 0 - 12dB |
| RMS Power @ 4 Ohms | 4 x 55 Watts |
| RMS Power @ 2 Ohms | 4 x 85W |
| Input Sensitivity | 0.2V - 5V |
Instructions for connecting the power supply and turning on the amplifier, emphasizing battery disconnection.
Guidelines for connecting loudspeakers in 2-channel and bridging modes, including impedance requirements.
Procedure for adjusting the input sensitivity (gain) to achieve optimal sound quality.
Guide on setting the highpass filter for mid-range/tweeter speakers and the 'FULL' setting for larger speakers.
Instructions for setting the lowpass filter when connecting a subwoofer for precise bass reproduction.
Details on using the bass boost switch for 6 or 12 dB bass enhancement.
Information on using the treble boost switch for 6 or 12 dB treble enhancement.
Explanation of the protection circuit and status indicators (PRT/PWR LED).
Checks for proper amplifier connections, fuses, ground, and voltage supply.
Troubleshooting steps when the PROTECT LED is red, indicating shorts or overheating.
Steps to check for audio output issues, including RCA input connections and cable integrity.
Diagnosing and resolving popping noises when turning the amplifier on and off.
Methods to eliminate engine noise interference by managing signal and ground wiring.
To Next Page
