Renkforce RF-IR-200 - FM Radio Mode

51
3Managing station list
1. Highlight the station to be edited in the station list.
2. Press the arrow button
(9).
3. The menu shows other options, enabling to move or delete the station.
j) FM radio mode
For this mode, the antenna (1) must be extended completely. A network connection is not required for this
mode. If no stations can be received or only a few, reorient the antenna (1) and/or relocate the device.
Placing the unit near a window has a positive effect on the reception quality.
1Scan for FM radio stations
1. Press the button (8) and select the menu item “FM RADIO” using the rotary knob (11) or arrow buttons and
(9).
The menu item “FM RADIO” can also be accessed directly by pressing the Mode button (3).
2. Presstherotaryknob(11)toconrmtheselection.
 WhenthismodeiscalledupforthersttimeornoFMscanhasbeenperformedyet,thedeviceasks
whether it should start a station scan. Press the rotary knob (11) to start the search.
3. After the station scan has been performed, a list of receivable stations is displayed.
4. Select the desired station using the rotary knob (11).
5. Presstherotaryknob(11)toconrmtheselectionandreceivethestation.
6. Press the arrow button
(9) to return to the station list and select another station.
New stations are not automatically added to the station list. A new station scan must be performed for this
purpose.
7. To start a new station scan, activate the FM station scan in the settings menu (see chapter “Settings”).