REPA ECO - Operations Before Commissioning; Periodic Checks; Trouble Shooting; Problems, Causes, and Solutions

9
MAINTENANCE
Immediately repair possible failures or damages to covers and electric appliances.
OPERATIONS BEFORE COMMISSIONING:
• General visual inspection (evident warps or damages of structure, protections, etc.);
• Check of the conditions of the power supply cable.
The softener does not require any kind of ordinary maintenance but the check and refill of salt.
The hour set must correspond to current time. It is important to check the softener periodically to safeguard the eciency
of connected devices.
These operations include checking water hardness and input and output capacity, the right execution of the dierent stages
and the conditions of resins to replace them if necessary.
DANGER
Never perform the operations above with wet or damp hands.

TROUBLE SHOOTING
PROBLEMS, CAUSES AND SOLUTIONS
PROBLEMS CAUSES SOLUTIONS
Regeneration starts at a wrong time Timer set up incorrectly Set up the timer
The programmer stops during
the regeneration cycle
Burnt out engine Replace
Power supply failure Check connection
Incorrect voltage or frequency Check the right voltage or frequency
The camshaft is blocked
Remove damaging bodies from the valve
or from the camshaft
Excessive supply pressure Install a pressure adjuster
The softener regenerates or discharges
water continuously
Valve 3 or 4 or both remain open
Remove damaging bodies that could
make the valves remain open
Power supply failure Check the voltage
Blocked or burnt out engine Replace the engine
PERIODIC CHECKS
AFTER THE FIRST 6-12 MONTHS, AND THEN EVERY 6-12 MONTHS:
Clean the salt container following the procedure hereunder:
• Remove the remaining salt from the bottom;
• Clean all the walls of the container from muddy, oozy or dry salt deposits;
• Rinse several times with running water using a water disinfectant such as Amuchina and a sponge;
• Rinse again, add the same quantity of water and then add the salt.
Periodically clean the washable cartridge of the pre-filter by removing all impurities from the bottom and from the surface
of the cartridge. It is sucient to use running water.