Repose Contur - Quick Start Guide; Inflate Inflatable Inner Section; Insert Inflatable Inner Section into Contur Cover; Secure Repose Contur to Chair

11
AIR
AIR
2
1
3
Fitting Instructions
Lay Contur cover out with xing straps beneath.
Fold the Repose Contur inatable inner section lengthways, insert
into Contur cover and lay at with valve face down at head end.
(See g. 4) Close zip at both ends.
Ensure that the Repose Contur is positioned correctly before
securing. (See g. 5)
5
7
8
9
4
6
•
•
•
IMPORTANT NOTICE
REPOSE CONTUR CAN BE CLEANED AND REUSED. REPLACE IF PRODUCT
IS DAMAGED OR THREADBARE.
CHECK PRODUCT REGULARLY TO ENSURE CORRECT INFLATION LEVEL.
IN CASE OF DOUBT, REPEAT PUMPING PROCEDURE WITH THE USER
OFF THE PRODUCT.
KEEP AWAY FROM SOURCES OF DIRECT HEAT INCLUDING
CIGARETTES, AND SHARP OBJECTS ESPECIALLY PETS’ CLAWS THAT
MAY CAUSE A PUNCTURE.
POSITION ON THE CHAIR SHOULD BE CHECKED REGULARLY TO
ENSURE THE CORRECT AND SAFE USE.
FOR FURTHER INSTRUCTIONS AND INFORMATION, SEE PUMP.
IF DETERIORATION IN SKIN CONDITION IS NOTED, CLINICAL ADVICE
SHOULD BE SOUGHT AND IF SO ADVISED, DISCONTINUE USE OF
PRODUCT.
WHEN DEFLATED KEEP AWAY FROM BABIES AND SMALL CHILDREN.
PRECAUTIONS
ONLY USE REPOSE CONTUR OVERLAY WITH REPOSE CONTUR COVER.
REPOSE CONTUR CAN BE CLEANED AND REUSED.
CHECK PRODUCT REGULARLY TO ENSURE CORRECT INFLATION LEVEL.
IN CASE OF DOUBT, REPEAT PUMPING PROCEDURE WITH THE USER
OFF THE PRODUCT.
KEEP AWAY FROM SOURCES OF DIRECT HEAT INCLUDING
CIGARETTES, AND SHARP OBJECTS ESPECIALLY PETS’ CLAWS THAT
MAY CAUSE A PUNCTURE.
MAXIMUM USER WEIGHT 139KG.
POSITION ON THE CHAIR SHOULD BE CHECKED REGULARLY TO
ENSURE THE CORRECT AND SAFE USE.
REPOSE CONTUR COVER IS ONLY TO BE USED WITH REPOSE CONTUR
INFLATABLE INNER SECTION.
ONLY TO BE USED WITH RISER RECLINER CHAIRS WITH ARMS.
NOT TO BE USED AS A SLING OR A FLOTATION DEVICE.
FOR FURTHER INSTRUCTIONS AND INFORMATION, SEE PUMP.
REPLACE IF PRODUCT IS DAMAGED OR THREADBARE.
To Inate
Remove the Repose Contur inatable inner section from the tube,
ret the two tubes together to form a pump.
Connect the valve on the pump to the valve on the device - Push
to t (See g. 1).
Inate Repose Contur inatable inner section until you hear air
exhausting from the pump valve. Discontinue pumping and wait
until you no longer hear air escaping (See g. 2).
Disconnect from pump. Cover the valve on the device using the
solid end of the valve cap (See g. 3).
Turn over with valve underside and away from user.
•
•
•
•
•
FOR MORE INFORMATION  PLEASE SEE THE REPOSE CONTUR
INFLATABLE INNER SECTION INSTRUCTIONS, INCLUDED WITHIN THE
PUMP.
To Deate
Insert the open end of the valve cap into the device valve. Air can
now escape (See g. 10).
Fold and roll up the device starting at the point furthest away
from the valve until all air is expelled. (See g. 11).
Re-fold, and re-roll as tightly as possible (See g. 12).
Replace device into the pump. Ret the two tubes together and
rotate outer tube until it clicks closed.
•
•
•
•
REPOSE CONTUR COVER IS ONLY TO BE USED WITH REPOSE CONTUR
INFLATABLE INNER SECTION.
ONLY TO BE USED WITH RISER RECLINER CHAIRS WITH ARMS NOT TO
BE USED AS A SLING OR A FLOTATION DEVICE.
MAXIMUM USER WEIGHT 139KG
LIMITATIONS FOR USE
Quick Start Guide
Inate Inatable Inner Section
Insert Inatable Inner Section
into Contur Cover
Secure Repose Contur to Chair
1
2
3
10
12
Insert xing straps between the seat and arm rest, looping around
the back of the chair. (See g. 6)
Cross xing straps as shown. (See g. 7)
Clip the xing straps into place and adjust until secure. (See g. 8)
Loop bottom xing straps around either side of the foot rest until
secure. (See g. 9)
•
•
•
•