Resfriar R4 - Sensors and Control Panels; Sensor and Control Panel Information

28
• SENSOR (BLADE OR BUOY): In case the water tank is lled and the
signal of lack of water is still on.
• CONTROL PANELS R3, R4 AND R6: They control all the product
functions and can be used for roof air coolers in two voltages: 12
and 24V. It doesn’t have a dened life time, since it depends on the
maintenance and regular checks done. This product is equipped with
an internal safety circuit against motor, lamps and pumps short-circuits.
In case your roof air cooler stops working, always check the fan, pumps
and lamps rst, since the defect could not be on the control panel.
The control panel may turn o, protecting itself against some other
electrical defects. Check also the general fuse in the battery.
Note: For this S6 roof air cooler, only use control panels with two
pumps, universal model.
Note: Never add into the water tank clothes softeners, essences,
perfumes or other substances. These products generates bubbles,
leading to water leakage inside of the cabin.
Keep the water tank always clean and with pure water.
We recommend to use our Resfri Ar original antibacterial avoring.
R4 MODEL
R3 MODEL
R6 MODEL
BLADE BUOY