-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
CE Requirements:
•(Simple EU declaration of conformity) Henan Eshow Electronic Commerce Co.,Ltd declares that the radio equipment type is
in compliance with the essential requirements and other relevant provisions of RED Directive 2014/53/EU and the ROHS
Directive 2011/65/EU and the WEEE Directive 2012/19/EU; the full text of the EU declaration of conformity is available at the
following internet address: www.retekess.com.
•Disposal
The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that in the European
Union,all electrical and electronic products, batteries, and accumulators (rechargeable batteries) must be taken to
designated collection locations at the end of their working life. Do not dispose of these products as unsorted
municipal waste. Dispose of them according to the laws in your area.
IC Requirements:
Licence-exempt radio apparatus
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
RF Warning Statements
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure
condition without restriction.
RF Exposure Information
•DO NOT operate the radio without a proper antenna attached, as this may damage the radio and may also cause you to
exceed RF exposure limits. A proper antenna is the antenna supplied with this radio by the manufacturer or an antenna
specifically authorized by the manufacturer for use with this radio, and the antenna gain shall not exceed the specified gain
by the manufacturer declared.
•To avoid interference, turn off the radio in areas where signs are posted to do so.