01
Getting Acquainted
LED indicators
Serial number Name
1 PTT
2 Side Key
3 Channel knob
4 Power /VOL knob
5 LED indicators
6 SP / MIC
7 Mic
LED indicator Status
Green light is always on Being received
Red light is always on Being transmited
Green light flashing slowly Being scanned
Prepare for use
Do not shake the radio by holding the top of the antenna to avoid degrading the performance and cycle life of the
antenna.
Install the back clip
1.Take out the battery pack and back clip parts from the inner box.
2. Align the back clip with the notched end of the battery pack and push it in smoothly.
Install the battery
1. Align the battery positioning post with the battery slot in the back case, gently press the top of the battery and
snap it into the battery.
2. The battery unloader will naturally slide off and lock the battery pack.
Installing accessories
1. Lift the accessory interface cover and push the audio accessory into the interface smoothly.
2. Make sure the radio is turned off before pushing in.
Charging
Since the battery is not fully charged at the factory, please complete the necessary pre-charging of the new
battery before use! General
Under normal circumstances, the battery needs to be charged for a full 5 hours when it is used for the first time.
Please make sure that the radio is turned off when charging.
To Next Page
Loading...
Need help?
General
