What’s in the box?
Included in every box will be:
• ArcadeR joystick
• Domed dust cover
• Ball top
More recent shipments also include:
• Neoprene shaft cover
• Rubber washer to hold the dust cover down
• Additional wiring harnesses.
NOTE: Some ArcadeR’s may be shipped with a second restrictor gate. See the
F.A.Q. for more details
Setting up the ArcadeR
To set up the ArcadeR for the first time, place the domed dust
cover over the stick shaft. You may also, if included fit the
rubber washer above the dust cover, and the neoprene shaft
cover. Finally screw on the ball top. If no washer is used, then
the dust cover will freely move around – this is normal.
Holding the joystick shaft while turning the ball top finger tight
should be enough to keep it in place, however there is also a
slot cut into the bottom of the joystick shaft. You can use a
screwdriver to brace the stick shaft when fitting the ball,
enabling it to be tightened further.
To Next Page
Loading...