REV Maverick - Page 4

To Next Page

To Previous Page

CARTON CONTENTS

ASSEMBLY INSTRUCTIONS

1 x Maverick Electric Bike

1 x Owner’s Manual

2 x Keys for Battery

1 x Battery Charger

1 x Multitool

Please Note: This manual is not intended as a detailed

service, repair or maintenance manual. Please seek

assistance from your dealer or a qualied bicycle technician

for service and repairs. To clarify, the name of this electric

bike in other countries is “Greaser”. Rev Bikes has the

approval of Michael Blast to change the name to ‘’Maverick”

for the New Zealand market.

Your bike has been pre-assembled and requires only just a few steps to get it ready for you to ride:

Open the box. Carefully lift the bike out of the box as the bike weighs 28kg. We recommend

that you seek help so that two people lift the Maverick from the inner cardboard box so as not

to damage the bike, nor cause a lifting strain to yourself. Alternatively, you can carefully cut the

cardboard to ‘expose’ the bike.

1. Remove the loose items and protective packaging around the bike.

2. Fit the handlebar using a 6mm hex key, remove the top half of the

handlebar clamp, locate the handlebar into the bottom half of the

handlebar clamp and ensure the cables are not in any way tangled with

the LCD display unit on the left-hand side of the bike. When sitting on the

bike looking forward, insert the top half of the handlebar clamp and install

the 4x6mm Hex head bolts, and initially tighten slightly while making sure

the top clamp is sitting evenly on the bottom handlebar clamp. Adjust the

handlebars to the desired angle and tighten the 4x6mm hex bolts rmly

so the bars do not move up or down when pressure is applied.

Do not adjust the handlebar settings when the hex bolts are rm

as this will result in damage to the handlebar.

3. Adjust the seat up or down by pulling the clamp handle away from the

seat post and loosen the clamp around the seat stem. Slide the seat

up or down to suit the rider. Once you have the preferred seat height,

gently tighten the clamp against the seat stem and move the clamp handle

inwards towards the seat post so it is held tight by the clamp. Make sure

the seat is not set above the maximum height marks on the seat post.

The pedals have been labelled “L” for the left and “R” for the right-hand

side. Attach and tighten them with a 15mm spanner turning anti clockwise.

HEX BOLTS

SEAT CLAMP