REV Maverick - Safety and Checks; Helmet Safety; Mechanical Safety Checks

MECHANICAL SAFETY CHECKS
• Check the condition of your “Maverick” bike before every ride.
• Make sure all nuts, bolts or any xings are not loose and pay attention to the axle nuts
and handlebar stem bolts
• Make sure the tyres are correctly inated to 25-30 psi (175-205 kPa)
• It is recommended you take your “Maverick” bike to be serviced and checked by
a bicycle technician once you have done 150 kilometres of riding. This is a good
standard practice for any new bike as cables will stretch and components will ‘bed in’.
The service should include spoke tensioning for both front and rear wheels along with
a general check to ensure all nuts and bolts are tight.
PASSENGERS
The Maverick is designed for the rider only.
Do not carry any additional passengers on the front or rear of the bike.
This bike is designed to have a maximum rider weight of 130kg.
HELMET SAFETY
Always wear an approved helmet while riding your “Maverick” electric bike and follow
the helmet manufacturer’s instructions for the tting and use of your helmet. It is your
responsibility to familiarise yourself with the relevant New Zealand laws of where you can
ride your bike and that you comply with all road safety rules. Rev Bikes recommends the
Livall BH51 M helmet when riding the “Maverick”.