Revamp PROGLOSS AUTO WAVE & CURL - Page 2

EN / 2
AUTO WAVE & CURL
Create glossy bouncy waves and curls the fast and easy
way. Revamp Auto Wave and Curl’s temperature-controlled
rotating barrel carefully wraps the hair for you, producing
eortless even curls every time.
PROGLOSS™ SUPER SMOOTH OILS
Every product in the Revamp haircare range is infused with
PROGLOSS™ SUPER SMOOTH OILS - enriched with Argan,
Keratin and Coconut for ultimate smoothness and shine.
PREPARING FOR USE
• Before use, ensure hair is clean, dry and tangle-free.
• Plug the appliance into a 220-240V mains power supply.
• Ensure the temperature setting starts at OFF.
• Slide the power switch up to your chosen temperature.
See table below.
SETTING HAIR TYPE TEMPERATURE
Low Fine, bleached or
damaged hair
150°C
Medium Normal or dyed hair 180°C
High Thick or wavy hair 210°C
CREATING PERFECT CURLS
• Separate each layer of hair into sections 3 cm wide.
Smooth each section of hair by brushing or combing
through the section (from scalp to hair ends) prior to
curling.
• For extra protection, apply a heat protection spray.
• Choose the direction of the curl
by moving the direction switch
(Feature 2) to the right or to the
le as in diagram A. Work on
one side of the head at a time.
When you move on to the other
side, move the direction switch
over so that your curls all face
the same way (A).
• VERY IMPORTANT When curling your own hair, be sure
to hold the device with the buttons facing towards
you. See (B). If curling a friend’s hair for them, have the
buttons facing towards them.
• Thread the hair through the front circular chamber, then
down through the rear circular chamber of the product
• Feed a section of hair between the plates holding the
appliance around 50-75mm away from your head. (D)
• Press and hold the curling button and the hair will
be automatically drawn into the heated barrel. Keep
holding the button while the hair is curled around the
barrel and until you hear the beeps (E).
• The first beep is heard aer 10 seconds which is
suicient time to curl finer hair. For thicker hair or larger
sections, allow up to a maximum of 30 seconds (5
beeps)
• Aer the desired time, release the button and wait
for the barrel to stop rotating before lowering the
appliance from the hair to release your curl.
• Caution! When the curling mechanism has stopped,
always pull the product
downwards to release the
curl.
• Repeat for each hair section,
allowing each curl time to
cool in between.
• Aer use, switch o the
appliance, unplug and allow
to cool before storing away.
• Caution! If the appliance is
used incorrectly, it can get stuck. Should a tangle occur,
firstly turn the appliance o and then pull the product
downwards until the hair is fully released.
SETTING NUMBER OF BEEPS TIME
1 1 beep 5 seconds
2 2 beeps 10 seconds
3 3 beeps 15 seconds
4 4 beeps 20 seconds
5 5 beeps 25 seconds
6 6 beeps 30 seconds
• Repeat for each hair section, allowing each curl time to
cool in between.
• Aer use, switch o the appliance, unplug and allow to
cool before storing away.
Follow us on revamphair.com for the latest hair tips and
advice.
Please note:
• To prevent hair damage, do not curl the same section
of hair more than twice
• As with all heated appliances, avoid frequent use to
prevent damage to the hair
• Avoid over use of styling products as this may
deteriorate the coating on the barrel.
• The barrel end of the appliance gets very hot during
FEATURES
1. Barrel
2. Curl direction Switch
3. Curling Button (with audible beep
for dierent curl types)
4. On/ready LED
5. On/ O/ Temperature Setting
Switch
6. Non-slip heat-proof silicone mat
A B
A B
CORRECT! Appliance is
facing the correct way
towards the front (B).
WRONG! Appliance is
back to front (C)
B C
A B
E
FRONT
BACK
A
B
2
4
53
1
6