Revolution 26 - Fasten Throttle Lever and Cable Thumb Wheel; Fill Engine with Oil; Remove Mower from Pallet

4. Using the screws supplied, losen the tape and fasten the throttle lever “C” and cable thunb wheel
“D” on the Outer Left hand side of the handle as shown.
5. Fill the engine with oil as instructed in
the engine manual.
6. Loosen or cut the ties holding the
front roller to the pallet. Carfully push
the mower off the pallet.
www.reelrollers.com 032354.A.0
Oil Fill
Cable Ties