Installation and Maintenance Instructions
•
Falk Steelflex
®
Type T10 & T20 (Page 1 of 9)
Rexnord Industries, LLC, 5555 S. Moorland Rd., New Berlin, WI 53151-7953 428-111
Telephone: 262-796-4060 Fax: 262-796-4064 02/2012
e-mail: info@rexnord.com web: www.rexnord.com Supersedes manuals 428-110, 112, 110 - 04/2005
This is the Original Document in English Language
Figure 1 - Steelflex T10 & T20 coupling range
1. General Information
1.1. Falk Steelflex Couplings are designed to provide a mechanical connection between the rotating shafts of mechanical equipment,
using a grid spring to accommodate inherent misalignment while transmitting the power and torque between the connected
shaft.
1.2. These instructions are intended to help you to install and maintain your Falk Steelflex coupling. Please read these instructions prior to
installing the coupling, and prior to maintenance of the coupling and connected equipment. Keep these instructions near the coupling
installation and available for review by maintenance personnel. For special engineered couplings, Rexnord may provide an engineering
drawing containing installation instructions that take precedence over this document.
1.3. Rexnord Industries, LLC owns the copyright of this material. These Installation and Maintenance instructions may not be reproduced in
whole or in part for competitive purposes.
1.4. Symbol descriptions:
Danger of injury to persons.
Damages on the machine possible.
Pointing to important items.
Hints concerning explosion protection.
Type T10
Sizes 1020-1170
Type T10
Sizes 1150-1260
Type T20
To Next Page
Need help?
General
