Safety instructions 13/60
RE 91616-01-B/10.2014, A6VE Series 65 and 71, Bosch Rexroth AG
CAUTION
High noise levels during operation!
Danger of hearing damage, deafness.
The noise emission of axial piston units depends on, among other factors,
rotational speed, operating pressure and installation conditions. The sound
pressure level may rise above 70 dB (A) during normal application conditions.
▶ Always wear hearing protection when in the vicinity of the operating axial
pistonunit.
Hot surfaces on the axial piston unit!
Risk of burns!
▶ Allow the axial piston unit to cool down sufficiently before touching it.
▶ Wear heat-resistant protective clothing, e.g. gloves.
Improper routing of cables and lines!
Tripping danger and damage to equipment!
▶ Lay cables and lines so that they can not be damaged and nobody can trip
overthem.
Contact with hydraulic fluid!
Health hazard / risk of health impairment, e.g., eye injuries, skin damage, poisoning
on inhalation.
▶ Avoid contact with hydraulic fluids.
▶ When working with hydraulic fluids, strictly observe the safety instructions
provided by the lubricant manufacturer.
▶ Use your personal protective equipment (e.g., safety glasses, safety gloves,
suitable working clothes, safety shoes).
▶ If hydraulic fluid should, nevertheless, come into contact with your eyes, get into
your bloodstream or be swallowed, consult a doctor immediately.
Escaping hydraulic fluid due to machine/system leakage!
Risk of burns and risk of injury due to escaping oil jet.
▶ Depressurize the machine/system and repair the leak.
▶ Never attempt to block or seal the leak or oil jet with a cloth.
2.7 Personal protective equipment
The personal protective equipment is the responsibility of the user of the axial piston
unit. Observe the safety regulations and provisions in your country.
All components of the personal protective equipment must be intact.
To Next Page
Loading...
Need help?
General
