REXROTH A6VE Series 71 User Manual

24/60 Transport and storage
Bosch Rexroth AG, A6VE Series 65 and 71, RE 91616-01-B/10.2014
If a dismounted axial piston unit is to be stored, it must be preserved against
corrosion for the duration of the storage.
The following instructions only refer to axial piston units which are operated with
a mineral-oil based hydraulic fluid. Other hydraulic fluids require preservation
methods that are specifically designed for them. In such cases, consult
BoschRexrothService, see chapter 10.5 “Spare parts” on page49.
Bosch Rexroth recommends the following procedure:
1. Clean the axial piston unit, see chapter10.1 “Cleaning and care” on page47.
2. Empty the axial piston unit.
3. For storage periods up to 12 months: Moisten the inside of the axial piston unit
with mineral oil and fill with approx. 100 ml mineral oil.
For storage periods up to 24 months: Fill the axial piston unit with corrosion
protection VCI 329 (20 ml).
The filling is carried out via the reservoir port T
1
or T
2
, see chapter 7.4 “Installing
the axial piston unit”, Fig. 11 to Fig. 14 on page 35.
4. Seal all ports so they are airtight.
5. Moisten the unpainted areas of the axial piston unit with mineral oil or with a
suitable, easily removable corrosion protection agent, e.g. acid-free grease.
6. Package the axial piston unit airproof together with desiccant in corrosion
protection film.
7. Store the axial piston unit so that it is protected against jolts, see “Requirements”
on page 23 in this chapter.
After removal

REXROTH A6VE Series 71 Specifications

General

Brand	REXROTH
Model	A6VE Series 71
Category	Engine
Language	English