42/60 Commissioning
Bosch Rexroth AG, A6VE Series 65 and 71, RE 91616-01-B/10.2014
Use only a hydraulic fluid that conforms to the following requirements:
You can find details of the minimum requirements on hydraulic fluids in Bosch
Rexroth data sheets 90220, 90221, 90222, and 90223. The titles of the data
sheet can be found in Table 1 “Required and supplementary documentation” on
page5. You can find details of permissible and optimal viscosity in data sheets
91615 and 91616.
To ensure the functional reliability of the axial piston unit, cleanliness level 20/18/15
according to at least ISO 4406 is necessary for the hydraulic fluid. At very high
hydraulic fluid temperatures (+90 °C to maximum +115 °C), cleanliness level
19/17/14 according to at least ISO 4406 is necessary. For permissible temperatures,
see data sheets 91615 and 91616.
1. Place a drip tray under the axial piston unit to collect any hydraulic fluid that may
leak.
NOTICE! Contaminated hydraulic fluid!
The cleanliness levels of hydraulic fluids on delivery do not normally conform to the
requirements for our components.
▶ Use a suitable filter system to filter hydraulic fluids during filling to minimize solid
impurities and water in the hydraulic system.
2. Fill and air bleed the axial piston unit via the appropriate ports, see chapter 7.3
“Installation position” on page 27. The hydraulic lines of the system must also
be filled.
NOTICE! Damage to equipment due to improper lubrication!
Product can be damaged or destroyed.
▶ When using a shut-off valve in the drain line, makes sure that the input of the axial
piston unit can only be started when the shut-off valves are open.
3. When using a shut-off valve in the drain line, only operate the axial piston unit
when the shut-off valves are open.
To Next Page
Loading...
Need help?
General
