12-2 Operating IndraDyn A Motors Rexroth IndraDyn A
12.2 Deactivation
In the case of malfunctions, maintenance measures or to deactivate
the motors, proceed as follows:
1. Observe the instructions of the machine documentation.
2. Use the machine-side control commands to bring the drive to a
controlled standstill.
3. Switch off the power and control voltage of the drive controller.
4. Only for MAD: Switch off the motor protection switch for the motor
blower.
5. Switch off the main switch of the machine.
6. Secure the machine against accidental movements and against
unauthorized operation.
7. Wait for the discharge time of the electrical systems to expire and
then disconnect all electrical connections.
8. Before dismantling, secure the motor and blower unit against falling
or movements before disconnecting the mechanical connections.
9. Log all measures taken in the start-up report.
12.3 Dismantling
DANGER
Fatal injury due to errors in activating motors
and moving elements!
⇒ Do not work on unsecured and operating machines.
⇒ Secure the machine against accidental movements
and against unauthorized operation.
⇒ Before dismantling, secure the motor and feeder
against falling or movements before disconnecting
the mechanical connections.
1. Observe the instructions of the machine documentation.
2. Please heed the safety notes and carry out all steps as described in
the anterior instructions in the chapter ”Deactivation”.
3. Before dismantling, secure the motor and feeder against falling or
movements before disconnecting the mechanical connections. At the
MAF motor, also empty the coolant channels.
4. Dismantle the motor from the machine. Store the motor properly!
5. Document all done measures in the start-up report and machine
maintenance plan.
To Next Page
Loading...
Need help?
General
