Synchronous Motors MKD Application Instructions 13-9
DOK-MOTOR*-MKD*******-PR07-EN-P Version7.0 19.05.2004
The holding brake is activated by the drive controller. This ensures the
proper on and off order in all of the operating states.
Note: A premature wear and tear of the holding brake is possible!
The holding brake wears after approx. 20.000 motor
revolutions in closed state. For that reason, do not use the
holding brake as a system brake to stop a moving axis! This
is permitted for EMERGENCY STOP situations only.
Please observe the instructions on putting the holding brakes into
operation described in the chapter entitled “Startup, Operation, and
Maintenance”.
To Next Page
Loading...
Need help?
General
