15-2 Assembly Synchronous Motors MKD
19.05.2004 Version7.0 DOK-MOTOR*-MKD*******-PR07-EN-P
Before mounting:
1. Procure tools, auxiliary materials, measuring and test equipment.
2. Control all components if they are clean.
3. Proof all components if they are obviously damaged. Defective
components may not be mounted.
4. Ensure that mounting can be done in a dry and clean environment.
5. Ensure that the holder for the motor flange is without burrs.
Mounting the MKD motors:
Mount the motor. All of the measures and tolerances specified in the
dimensional sheets must be kept.
To fix the flange, we recommend to use the screws and tightening
torques listed in the table below.
Motor frame
size
Recommended
screw size
Tightening
torque [Nm]
Minimum strength
MKD025 4x M4 3,1 8.8
MKD041 4 x M6 10,4 8.8
MKD071 4 x M8 25 8.8
MKD090 4 x M10 51 8.8
MKD112 4 x M12 87 8.8
Fig. 15-1: Locking screws
Note: The screwed connections must be able to take up both the
force due to the force of the motor and the forces acting
during operation.
If the optional holding brake is
used
To Next Page
Loading...
Need help?
General
