To Next PageTo Next Page
Need help?Do you have a question about the Reynolds Building Systems Best Barns Denver and is the answer not in the manual?
General| Brand | Reynolds Building Systems |
|---|---|
| Model | Best Barns Denver |
| Category | Outdoor Storage |
| Language | English |
Access the most current shed kit instruction book online for updates and details.
Contact information for assembly questions and details on kit materials.
Guidance on foundation considerations and required preparation before assembly.
List of necessary tools for constructing the shed kit.
Details on foundation dimensions and local building code requirements.
Cutting 2x4 boards to create joist headers for the floor frame.
Preparing and securing 2x4 treated boards as floor joists.
Positioning the floor frame onto 4x4 runners and ensuring it is square.
Laying the 4x8 flooring panels over the constructed floor joists.
Constructing the base plates for the roof trusses using 2x4s and gussets.
Assembling the main truss structure by joining halves and securing them.
Repeating the truss assembly process to create all required trusses.
Assembling the structural components of the roof gables using rafters and plates.
Adding central braces and reinforcing elements to the roof gables.
Repeating the gable assembly process for the front section of the shed.
Attaching pre-cut siding panels to the exterior of the roof gable frames.
Applying trim boards along the edges and sides of the roof gables.
Constructing the main structural header for the door opening.
Building the base plate for the front wall, including the door opening.
Installing studs and door jacks for the front wall structure.
Securing the pre-assembled door header into the front wall frame.
Attaching siding panels to the completed front wall frame.
Positioning and marking 2x4 boards to form the side wall plates.
Securing the 80-1/4" studs between the prepared wall plates.
Ensuring the wall frame is square before applying siding panels.
Butting two 10' side wall frames together to form a longer section.
Attaching siding panels to the assembled 20' side wall frames.
Positioning and marking the 68-1/2" boards for the back wall construction.
Securing the 80-1/4" studs between the back wall plates.
Attaching siding panels to the completed back wall frame.
Cutting and joining lumber pieces to construct the center wall brace.
Setting the back and side wall panels in place and securing the corners.
Attaching the central brace between the side walls for stability.
Finalizing the installation of the center wall brace to ensure plumb walls.
Applying 1x4 trim boards to the corners and top edge of the back wall.
Applying 1x4 trim boards to the corners and top edge of the front wall.
Securing the pre-assembled roof gables to the top of the side walls.
Adding 2x4 tie plates along the top edge of the side walls for reinforcement.
Constructing the shelf structure using 2x4s and blocks for gable support.
Attaching the shelf to walls and installing OSB panels for rigidity.
Measuring and marking the precise positions for roof trusses on the gable ends.
Fastening the roof trusses to the wall plates using hangers.
Attaching soffit boards to the gable ends and sides of the shed.
Laying OSB panels to create the roof deck, starting from the rear.
Completing the roof sheathing and installing plyclips for ventilation.
Attaching trim pieces around the front gable and door opening for finishing.
Installing metal roof edging and felt paper for protection.
Applying the final roofing material according to manufacturer instructions.
Attaching hinges and mounting the main doors into the opening.
Fitting barrel bolts and latches for door security and proper operation.
