HEAT PUMP AND TANK ASSEMBLY
27
15. Remove the tab on the side of the electrical entry to the heat pump module to accommodate the
electrical conduit.
Pliers or tin snips may be required to remove the tab.
Step 15
remove the tab on the side of the electrical entry to the heat pump module
16. Retrieve the three (3) brass studs from the kit and screw into the three (3) threaded inserts on the side
of the tank closest to the wall.
These brass studs will assist in aligning the heat pump module for connection to the storage tank.
Step 16
screw in brass studs into threaded inserts
To Next Page
Loading...
