15
TM063 701, 702 & 703 Series Boiling Water Unit Service Instructions
Revision D: Feb 2017
This document is stored and maintained electronically by Service. All printed copies not bearing this statement in RED are deemed “uncontrolled”
Setting the Clock
1. Press and release the (P) button, ‘Clock’ is displayed flashing on the screen.
2. Press and release the (✓) button to confirm selection. ‘Set Clock Day’ will be
displayed on the screen with the day selection shown flashing.
3. Press and release the (▲) button until the desired day is selected.
4. Press and release the (✓) button to confirm selection. ‘Set Clock HOUR’ will be
displayed on the screen with the hours section of the time shown flashing.
5. Press and release the (▲) button until the desired hour (24 hour time) appears
flashing on the screen.
6. Press and release the (✓) button to confirm selection. ‘Set Clock MIN’ will be
displayed on the screen with the minutes section of the time shown flashing.
7. Press and release the (▲) button until the desired minute appears flashing on the
screen.
8. Press and release the (✓) button to confirm selection. The display will revert to the
main menu and the time setting will be saved.
Selecting STD or AUTO Mode
1. Press and release the (P) button until ‘Timer STD/AUTO’ is displayed flashing on
the screen.
2. Press and release the (✓) button to confirm selection. ‘STD’ will be displayed
flashing on the screen.
3. Pressing and releasing the (▲) button alternates between the ‘STD’ and ‘AUTO’
icons.
4. Press and release the (✓) button when the ‘STD’ or ‘AUTO’ icon is shown on the
display. The display will revert to the main menu. If ‘STD’ is selected the unit will
operate 24 hours a day. If ‘AUTO’ is selected the unit will operate according to the
pre set times on the timer (refer to ‘Programming Set ON/ OFF Times’ below).
Note: If the timer is in ‘AUTO’ mode and is in an ‘OFF’ period, the pressing of any Timer
button or drawing water will reactivate the unit. The unit will then operate normally until the
next programmed ‘OFF’ time.
Programming ‘Set ON/OFF Times’ (For Use in ‘AUTO’ Mode)
Note: A highlighted numeral i.e. 7:00 indicates that the highlighted numeral 7 is flashing on
the display. X:XX is your time setting.
1. Press and release the (P) button until ‘Set ON/OFF Time’ is displayed flashing on
the screen.
2. Press and release the (✓) button to confirm selection.
‘SUN 7:00 – 7:00 Set ON hour’ will be displayed on the screen.
3. Press and release the (▲) button until the desired hour appears flashing on the
screen.
4. Press and release the (✓) button to confirm selection.
‘SUN X:XX – X:XX Set ON minute’ will be displayed on the screen.
To Next Page
Loading...
