TEMPERATURE CONTROL – DELUXE
29
To operate the Kitchen Deluxe controller:
1. Turn off the Bathroom Deluxe controller(s)
If a temperature setting is displayed and the ACTIVE
light is not glowing, it is necessary to turn off the
Bathroom Deluxe controller(s) to gain priority.
Refer to the notes on the Kitchen Deluxe controller
on page 28.
2. Turn on the Kitchen Deluxe controller
Press the ON / OFF button.
The light in the ON / OFF button and the ACTIVE
light will both glow.
The Kitchen controller temperature setting will be
displayed. This is the lower of the previous setting
and:
871 series 50°C
875 series 48°C
3. Select the temperature setting
Press the up (i) button or down (j) button.
When the up (i) button is pressed, the voice
prompt will sound;
“hot water temperature has been increased”
When the down (j) button is pressed, the voice
prompt will sound;
“hot water temperature has been decreased”
Refer to “Temperature Adjustment – Deluxe
Controllers” on page 27.
The selected temperature setting will be displayed
on all Deluxe controllers.
4. Open the hot tap.
The operating light will glow on all Deluxe controllers.
5. Close the hot tap.
The operating light will go out on all Deluxe controllers, if
no other hot tap is open.
6. Turn off the Kitchen Deluxe controller
Press the ON / OFF button.
The ACTIVE light and the ON / OFF light will go out
and the temperature display panel will go blank.
Important: Turn off the Kitchen Deluxe controller after hot water usage is finished in the kitchen and / or
laundry. Refer to Important note for Bathroom Deluxe controllers on page 30.
BATH(l)
To Next Page
Loading...
