Commercial Air to Water Heat Pump Water Heater
26
HEAT PUMP AND TANK ASSEMBLY
Note: Top unit can be 9530XXH0 or 9520XXH0.
STORAGE TANKS
Commercial storage tanks are employed to store the hot
water generated by the heat pump. The tanks must be
manifolded to ensure even distribution of the stored ener-
gy. More than one bank can be used. Follow the Manifold
Arrangement diagram in this Manual when manifolding
the tanks.
Refer to the installation instructions supplied with the stor-
age tanks for specific information relating to the installa-
tion of the storage tanks.
PRIMARY CIRCULATOR
Each heat pump requires a primary circulator to ensure
the correct flow rate and temperature rise is achieved.
Where more than one heat pump is installed the common
manifold system must be sized to accommodate the total
flow of all the primary pumps running simultaneously.
Staking kits available for horizontally vented
heaters. See Kit Instillation Instructions for
proper stacking
PART NUMBER DESCRIPTION
45263 HPHD-60 Horizontal Stacking Kit
45264 HPHD-135 Horizontal Stacking Kit
To Next Page
Loading...
