IKONIC Tankless Water Heater Service Manual
69
FLAME AND IGNITER ROD
HOW TO REMOVE COMPONENTS
1. Remove the hook lm part of the Over Heat Limiter
(OHL ). DO NOT cut the lm.
2. Remove flame rod and igniter rod wires wire from the
rods.
3. Remove 3 screws from flame rod bracket, and pull
the rod bracket.
NOTE: When reassembling flame and igniter rods,
please use a spare gasket if the condition of the gasket
is not good.
The spare gasket is located at lower left in the unit.
Flame Rod
Igniter Rod
To Next Page
Loading...
