45
XVersL and XFIIRE units
1. Pull the controls bezel to release the 2 snap fasteners.
Figure 109. Pull Controls Bezel
2. Gently pull down the bezel to avoid damages to
harnesses and control board.
3. Disconnect the touchscreen power cable.
Figure 110. Disconnect Touchscreen Power Cable
4. Use Wire cutters to cut the Wire jumper labeled as
"Cut to permanently disable Wi-Fi". See Figure 111.
NOTE: By cutting this wire, the Wi-Fi module is disabled.
Any attempt to modify the wire or modify the board will
void touchscreen assembly warranty.
Figure 111. Cut to Disable Wi-Fi
To Next Page
Loading...