8 Rheem Heating, Cooling and Water Heating
RHEEM RESIDENTIAL TANKLESS
95 TANKLESS SERIES
Continuous hot water for 3 bathroom homes*
RTG-95DV indoor direct vent and RTG-95X outdoor
natural and LP models – 11,000 - 199,900 BTU max.
9.5 gal./min at 35° F rise max., 7.4 gal./min. at 45° F rise
Limited Warranty:
12-Year on heat exchanger, 5-Year on parts, 1-Year on labor
See Residential Warranty Information Brochure for complete warranty information.
•
New! 3"/5" Concentric Vent System with Integrated Condensate Collector
•
Connects to Metal Fab Inc., 3"/5" Concentric Venting without an adapter
•
New! Next Generation Burner Technology
•
Industry Best! .26 GPM Minimum Flow Rate, .40 GPM Minimum
Activation Flow Rate
•
UMC-117 remote control and 10 ft. of thermostat wire is included
•
EZ-Link™ cable available for high demand applications to connect two tankless
units to operate as one
•
New! Manifold up to 6 units with an optional MIC-6 manifold control board
•
Exclusive! All Rheem models can be linked in up to 20 unit manifold installations
by using the optional MIC-180 and MICS-180 manifold control assembly
•
High-altitude capability – up to 9,840 ft. elevation above sea level
(no chip required)
•
Exclusive! Guardian OFW™ overheat film wrap
•
All Rheem tankless models are third-party efficiency certified by GAMA
•
Continuous hot water, energy saving and compact, space saving design
•
Intelligent electronic controls designed to increase energy efficiency and safety
•
Self Diagnostic System
•
Digital display shows temperature setting and maintenance codes
•
Built-in electric blower
•
Supplied with a 120 volt power cord
•
Environmentally friendly Low NOx burner meets SCAQMD rule 1146
requirements
•
Freeze protection to -30° F
Product appearance may differ.
* Based on simultaneous showers using 2.5 gallons per minute. Flow rates vary depending
on temperature of cold water supply.
Tankless water heaters
Continuous hot water
See reverse for specifications.
199,900 BTU
INDOOR DIRECT VENT
199,900 BTU
OUTDOOR
The 95 Series Tankless models can be
converted for Commercial Installations
See Commercial Warranty Brochure for details.
RTG-95DVN*
11,000-
Indoor
85° to
4.3 7.4 9.5 3/4 3/4 25-5/8 13-7/8 9-7/8
3 by 5
54 .82
$223/$374
199,900
Direct Vent
140° F*
CONCENTRIC
RTG-95XN*
11,000-
Outdoor
85° to
4.3 7.4 9.5 3/4 3/4 23-5/8 13-7/8 8-7/8
N/A
54 .82
$223/$374
199,900 140° F*
RHEEM TANKLESS WATER HEATERS FOR 3 BATHROOM HOMES
All models are available in Natural Gas and Propane (LP).
For Propane replace the N with P when ordering.
• Factory set maximum temperature is 120° F. See Use and Care Manual for setting.
• Consult factory for information on sizing the application.
Vent Termination Kits are required for Direct Vent models. Contact your distributor for details.
Temperature Rise (° F)
Model Number 35°
45° 50° 60° 70° 77° 80° 90° 100°
RTG-95 Water Flow (GPM) 9.5 7.4 6.6 5.5 4.7 4.3 4.1 3.7 3.3
Above estimates are for sizing purposes only.
Proper gas pressure must be ensured to supply tankless gas water heaters – up to 199,900 BTU
for RTG-95 models. (Consult your gas supplier)
Rheem Water Heating and Heating & Cooling Products
101 Bell Road • Montgomery, AL 36117-4305
1-866-720-2076 • www.rheem.com
Rheem Canada Ltd./Ltée • Water Heater Divi
sion
125 Edgeware Road, Unit 1, Brampton, Ontario L6Y 0P5
Printed in U.S.A. 01/10 WP Form No. 101-50-95
These units are designed to meet or exceed ANSI (American National Standards Institute)
requirements and have been tested according to D.O.E. test procedures and meet or
exceed the energy efficiency requirements of NAECA, ASHRAE standard 90, ICC Code and
all state energy efficiency pe
rformance criteria for energy consuming appliances.
Before purchasing this appliance, read important energy cost and efficiency information
available from your supplier.
In keeping with its policy of continuous progress and product improvement,
Rheem reserves the right to make changes without notice.
Water Heater Flow Rate Curves
DESCRIPTION FEATURES ROUGHING IN DIMENSIONS (SHOWN IN INCHES) ENERGY INFO.
GAS WATER FLOW RATE VENT SHIP. D.O.E. ANN.
MODEL INPUT TEMP.
GPM @ 77° GPM @ 45° GPM @ 35°
CONNECTION DIAMETER WEIGHT ENERGY OP. COST
NUMBER BTU/HR. TYPE RANGE
RISE MAX. RISE MAX. RISE MAX. WATER GAS
HEIGHT WIDTH DEPTH (INCHES) (LBS.) FACTOR NAT/LP
Energy Factor and Average Annual Operating Costs based on D.O.E.
(Department of Energy) test procedures. D.O.E. national average fuel rate
natural gas $1.218/therm; LP $1.87/gallon
.
*COMMERCIAL OPERATION AVAILABLE WITH CONVERSION KITS:
RTG20214A FOR RTG-95DVN
RTG20214B FOR RTG-95DVP
RTG20214C FOR RTG-95XN
RTG20214D FOR RTG-95XP
Temperature range for commercial: 85° to 185° F.
SPECIFICATIONS