71
Start/Adjust
INSTALLATION INSTRUCTIONS
While “140” is blinking, press the UP and DOWN
adjustment buttons at the same time. “140” will appear
without blinking.
Press the UP or DOWN adjustment button to set the
desired temperature.
Turn on the gas and water to the water heater by
opening the shut-off valves.
To limit maximum water temperature setting to 120°F
(49°C):
Turn on the remote control.
Turn off the gas and water to the water heater by
closing the shut-off valves.
Press the DOWN adjustment button repeatedly until
100°F (38°C) or 85°F (29°C) shows in the LED display.
Hold the DOWN button until the number on the display
starts to blink.
While the number is blinking, press the UP and DOWN
adjustment buttons at the same time. The number will
stop blinking.
Press the UP or DOWN adjustment button to set the
desired temperature.
Turn on the gas and water to the water heater by
opening the shut-off valves.
4
5
6
1
2
3
4
5
6
Setting the Water Temperature (cont.)
To Next Page
Loading...
Need help?
General
