PRINTED IN U.S.A. 03/15 WP FORM NO. RR102C-15 Rev. 11
4
In keeping with its policy of continuous progress and product improvement, Rheem reserves the right to make changes without notice.
Rheem Water Heating • 101 Bell Road
Montgomery, Alabama 36117-4305 • www.rheem.com
Rheem Canada Ltd./Ltée • 125 Edgeware Road, Unit 1
Brampton, Ontario L6Y 0P5 • www.rheem.com
Water
Commercial Gas
Xtreme Water Heaters
INTEGRATED AIR & WATER
Recommended Specifications
(for trade reference only)
Water heater(s) shall be Xtreme model ________________,
manufactured by Rheem, having gas input of __________
Btu/h and a recovery rate of _____________ GPH at a 100°F
temperature rise when tested and certified at ____________
thermal efficiency. Water heater(s) shall have a storage
capacity of 90 gallons. Water heater(s) shall have the U.L.
seal of certification and supplied with a factory installed CSA/
ASME rated temperature and pressure relief valve. Tank(s)
shall be furnished with a tube bundle having a double coating
of high temperature porcelain enamel and furnished with
magnesium anode rods rigidly supported. Water heater(s)
shall meet or exceed the thermal efficiency and standby loss
requirements of current ASHRAE standards. Tanks shall have
a working pressure rating of 150 psi, and shall be completely
factory assembled, including a pressure regulator properly
adjusted for operation on ___________ gas with chromium
stainless steel burners. Controls will be arranged for safety
shutoff in event of pilot failure. Water heater(s) shall have front
and rear side inlet/outlet water connections. Water heater(s)
shall be covered by a three year limited warranty against tank
leaks.
When ordering ASME construction,
place (A) after the model number
(for trade reference only)
Water heater(s) shall be constructed in accordance with the
requirements of the ASME Boiler and Pressure Vessel Code,
Section IV Part HLW.
To Previous Page
Loading...
