Need help?Do you have a question about the RHEONIK RHE 08 and is the answer not in the manual?
General| Accuracy | ±0.1% of rate |
|---|---|
| Repeatability | ±0.05% of rate |
| Pressure Rating | 100 bar |
| Power Supply | 24 VDC |
| Material | Stainless Steel |
| Type | Mass Flow Meter |
| Measurement Principle | Coriolis |
| Fluid Temperature | -50°C to +150°C |
| Operating Temperature Range | -20°C to +60°C |
| Output Signals | 4-20 mA, Pulse |
| Process Connections | Threaded, Flanged |
Guidance on correctly installing the RHM sensor in pipe lines, considering vibration and orientation.
Details on connecting the RHM sensor to the RHE electronic unit using specific cables and wire configurations.
Instructions for installing the RHE transmitter unit, considering ambient conditions and avoiding direct sunlight.
Guidelines for connecting the power supply to the RHE remote unit, including voltage requirements and grounding.
Procedure for calibrating the meter's zero point, including conditions, steps, and recovery options.
Setting up the 4-20mA analog outputs for flow, density, or temperature, including output modes and scaling.
Tools for start-up checking and testing sensor malfunctions using frequency, phase shift, and temperature difference.
Menu for entering sensor-specific data like meter size, connection type, and maximum sensor operating temperature.
Guide to checking sensor electrical characteristics, voltages, and resistances for troubleshooting.
Explanation of the CE marking and explosion protection symbols for hazardous area installation locations.
Details on additional markings related to ignition temperature, explosion groups, and types of protection.
To Next Page