Page 11 / 19
• The assembly and installation must be carried out in accordance with the national
regulations of the country of use.
• The stove should be installed away from all flammable materials and at least 5 cm away
from walls.
• The installation location must have sufficient space and ventilation.
• The assembly and installation must, in all cases, comply with the safety requirements in
force.
• Remove all protective film and stickers before use.
• Refer Figure 1 for the illustrartion of an assembled stove.
4.3- Connecting to gas supply
Preparation
• Use suitable hose that meets below standards:
• The hose must not exceed 1.5 metres.
• Ensure the hose is free from stress, torsion, traction or bend.
• The regulator and safety valve must comply with the standards in force in the country of
marketing.
• Use with suitable gas supply only: either butane (G30) or propane (G31).
Connection
• Ensure the appliance control knob is set to the OFF position.
• Ensure gas regulator valve or the safety valve is set to the OFF position.
• Attach the appliance to gas supply with the flexible hose appropriately.
• Ensure the gas pressure is 28-30 mbar for butane gas, or 37 mbar for propane.
• After each connection, perform leakage test in well ventilated area and away from heat
source.
Leakage test
• Ensure the location is well ventilated and away from heat source.
• Prepare soapy water by mixing equal portion of water and non-ammonia detergent.
• Turn ON the gas safety valve.
• Transfer few drops of soapy water to the connections.
• If bubble forms, leakage are found, then turn OFF the gas safety valve and tighten the
connection. Repeat the test until no bubble is formed, or call for professional service.
4.4- Turn ON and OFF
Ignition
• Turn ON the gas safety valve.
• Push the control knob, then turn anticlockwise until a click is heard and the burner is lit.
• If it is not light, turn the knob to the OFF position and repeat the ignition process.
Power adjustment
• Turn the control knob to appropriate position for the power adjustment.
Turn OFF
To Next Page
Loading...