Auto Continue
Item Description Value
Auto Continue Sets the machine to ignore an error
with paper size or type and continue
printing. The printing stops temporarily
when an error is detected, and restarts
automatically after about ten seconds
using the settings made on the control
panel.
However, if the size of paper specified
on the control panel and that of the
paper loaded in the paper tray or the
paper size specified for the print job
do not match when printing restarts, it
may cause a paper jam.
• Off
• On
Default: [Off]
Toner Saving
Item Description Value
Toner Saving Sets the machine to print using a
reduced amount of toner (for prints
made by the copier function only).
• Off
• On
Default: [Off]
Low Humidity Mode
Item Description Value
Low Humidity
Mode
If the machine is used in a room where
humidity level is low, black lines of a
few millimeters thick may appear on
printouts with 75-millimeter spaces in
between. Selecting [On] for this setting
may prevent these lines from
appearing (wait for about one day
until this setting becomes effective).
Note that when this setting is enabled,
the machine automatically performs
self-maintenance in every 10 minutes.
• Off
• On
Default: [Off]
7. Configuring the Machine Using the Control Panel
230
To Next Page
Loading...
