Message Causes Solutions
Cannot copy.
Set original to ADF.
Combined copying could not be
performed because the originals
were not placed in the ADF.
• Use the ADF, even when copying a
single sheet.
• If you need to use the exposure glass,
select [Off] or [Manual 2Sd Scan
Mode] in [Duplex/Combine] under
[Copier Features], and then try again.
See page 209 "Copier Features
Settings".
Check Paper Size The paper size set for the
document differs from the size of
the paper in the indicated tray.
Press [Form Feed] to begin printing, or
press [Job Reset] to cancel the job.
Check Paper Type The paper type set for the
document differs from the type
of the paper in the indicated
tray.
Press [Form Feed] to begin printing, or
press [Job Reset] to cancel the job.
Connection Failed The line could not be connected
correctly.
• Confirm that the telephone line is
properly connected to the machine.
• Disconnect the telephone line from
the machine, and connect a standard
telephone in its place. Confirm that
you can make calls using the
telephone. If you cannot make calls
this way, contact your telephone
company.
Cooling down... If the internal parts of the
machine get hot while doing
continuous printing, a message
appears and printing stops.
Wait until the machine cools down and
resumes printing.
Cover open A cover is open. Close the cover completely.
Error and Status Messages on the Screen
327
To Next Page
Loading...
