3) Insert the film strip holder [A] into the film projector unit at the base film
setting position.
NOTE:
Push the film strip holder gently to confirm that the film strip
holder has been inserted correctly.
4) Turn on the test switch [B] on the projector control board and turn on
the projector unit main switch [C].
+
CAUTION
The lamp housing and reflector [D] will become very hot. The lamp
cooling fan [E] will start turning suddenly when the lamp housing
temperature becomes high. Keep hands away from those components
to avoid any injury.
5) Loosen the wing nut [F].
6) Adjust the position of the projected light by turning the dial [G] with a
hexagon wrench [H] until it is at the center of the 4" x 5" frame [I] which
is reflected in the mirror unit.
7) Tighten the wing nut [F].
8) Turn off the projector main switch and the test switch.
9) Reinstall the lamp cover and other covers.
[C]
[I]
[B]
[D]
[F]
[H]
[G]
[A]
[E]
Installation
SM 3-49 A172/A199
To Next Page
Loading...
