10) Enter SP Mode as follows:
1) Press the clear modes key.
2) Wait for 2 or 3 seconds while the display returns to the initial screen.
3) Enter "107".
4) Hold down the clear/stop key for more than 3 seconds.
11) Touch the SP ADJUSTMENT feature key [A].
Open page 14 in SP Adustments
Set AD-Vref Target Voltage for the FPU to a Value of 2.7.
Set the AD-Vref Coefficient (Data Mode) for the FPU to the following Value.
R-E = 66 G-E = 60 B-E = 65
R-O = 66 G-O = 60 B-O = 65
A
Rev. 6/13/97
⇒
[A]
A172/A199 3-49 SM
To Next Page
Loading...
