Fig.
27-A
Fig.
27-8
* If you keep the Shutter Release Button pressed halfway
down before the Flash Ready Lamp comes on, the Flash
will not be charged.
* Be careful not to place your finger in front of the Flash
Unit.
* If the Shutter Release Button is pressed before the Flash
Ready Lamp lights
up
, the shutter will not be released.
* The Flash can be used as a supplementary fill-in light
source for daytime photography to help eliminate shad-
ows. Cover the Photocell with
your
hand and press the
Shutter Release Button halfway. Then the Flash Unit pops
up
. Uncover the photocell and take the picture.
USING THE SELF-TIMER
This feature allows you to get into your own picture by allow-
ing the camera to take the picture
by
itself.
1. Place the camera on a tripod or other firm support.
2. Slide the Self-Timer Switch fully in the direction of the
arrow and the Self-Timer LED on the front of the camera
blinks. (Fig. 27-A,
27-8)
The picture will be taken in appro-
ximately 10d seconds.
Two
seconds before the Shutter is
released, the flashing
frequency
of the
LED
will increase,
giving you or your
subject
a visual signal that the shutter is
about to be released.
19
To Next Page
Loading...
