ENERGY SAVER MODES
SM 6-51 B044/B045/B046
Detailed
Descriptions
6.17.2 SYSTEM SETTINGS
The user sets up energy-saving operation using the following User Tool settings.
User Tool – System Setting Operation
Energy Saver timer
Sets time at which machine moves from standby to the
low-power mode.
•
The default is 15 minutes.
Energy Saver level Selects the low-power mode that the system uses. The
default is Level 2. (See below.)
Auto-Off Timer Sets time at which machine transitions to auto-off mode.
The default is 30 minutes.
AOF Allows user to disable auto-off. The default setting is on
(enabled). See Note below.
NOTE: If the customer requests that you disable auto-off, please inform the
customer that disabling of this feature will void Energy Star conformance
and is not recommended.
6.17.3 LOW POWER MODE LEVELS
The Energy Saver Level setting determines which power level is used when the
machine enters Low Power mode.
Mode Fusing Temp. Approx. Recovery Time
Low Power—Level 1
165°C
5 s
Low Power—Level 2
90°C
10 s
Low Power—Level 3 Room Temp. 20 s
6.17.4 AUTO-OFF LEVEL
Identical to low power mode level 3.
6.17.5 TRANSITION OPERATION
On entry into low-power or auto-off:
• Main power LED stays ON, operation switch and all other indicators OFF.
• System +5V power remains on.
The machine returns to standby power mode when any of the following "wake-up"
actions occurs:
• Pressing of operation switch
• Opening of platen cover
• Placing sheet in DF
• Wake-up signal from a PC
• Error or SC condition
To Next Page
Loading...
