PRINTER INSTALLATION
B441 1-2 SM
Printer Controller Installation
!
CAUTION
• Unplug the main machine power cord before starting the following
procedure.
If you install the fax option at the same time, the fax option must be
installed first. Otherwise you cannot install the fax option.
1. Remove the rear cover [A] (5 screws).
2. Remove the small cover [B] from the rear cover (cut it by the nipper).
• When you install the printer memory at the same time, please connect the
memory [C] to CN502 as shown.
• When you install the fax option, please remove the small cover [D] as shown.
Otherwise go to step 3.
3. Connect the harness [E] on CN507 as shown.
B441I501.WMF
B441I101.WMF
B441I102.WMF
[A]
[B]
[C]
[D]
[E]
To Next Page
Loading...
