User Tools (System Settings)
18
2
9. Pap.Tray Priority (for
Copy mode only)
When the optional paper tray unit is equipped with your machine,
you can select a default paper tray in the following conditions:
• When the operation switch is turned on.
• When the {
{{
{Clear Modes}
}}
} key is pressed.
• When the Copy Reset Timer comes into effect.
1: Tray 1
2: Tray 2 (optional paper tray unit)
Note
❒ Default: Tray 1
10Auto Tray Switch (for
Copy mode only)
If you load paper of the same size and direction in two trays, the
machine automatically switches to another tray when the tray in
use runs out of paper. You can set or cancel this setting. The op-
tional paper tray unit is required to use this setting.
Note
❒ Default: On
11Display Contrast You can adjust the brightness of the panel display.
12Measurement Unit You can select the unit of measurement.
Note
❒ Default: mm
Menu Description
Stella-AE-SysF_V4_FM.book Page 18 Friday, December 20, 2002 11:39 PM
To Next Page
Loading...
