Ricoh aficio 1013F - SP4-XXX (Scanner)

USING SERVICE PROGRAM MODE
SM 5-9 B044/B045/B046
Service
Tables
SP4-XXX (Scanner)
4
Mode Number/Name Function/[Setting]
Main Scan Magnification (Scanner)008*
1 Adjusts the magnification along the main scan direction,
for scanning.
[–0.9 ~ +9.0 / 0.0 / 0.1%/step] IAJ
• Use the ! key to select “+” or “–” when entering the
value
Leading Edge Registration (Scanner)010*
1 Adjusts the leading edge registration for scanning in
platen mode.
[–2.0 ~ +5.0 / 0.0 / 0.1 mm/step] IAJ
• (–): The image moves toward the leading edge.
• (+): The image moves toward the trailing edge.
• Use the ! key to select “+” or “–” when entering the
value
Side-to-side Registration (Scanner)011*
1 Adjusts the side-to-side registration for scanning in platen
mode.
[–0.9 ~ 0.9 / 0.0 / 0.1 mm/step] IAJ
• Increasing the value shifts the image to the right
• Use the ! key to select “+” or “–” when entering the
value
Scanner Free Run013
Performs a scanner free run with the exposure lamp on.
[0 = No / 1 = Yes]
• For details about free runs:
☛
5.1.7.
• After selecting “1”, press OK or ' twice to start the run.
Press % to stop.
White Plate Scanning
1 Start position
Adjusts the scanning start position on the white plate for
auto-shading.
[–3.0 ~ +6.0 / 0.0 / 0.1 mm/step]
• Positive settings move the position away from HP.
015*
2 Scanning area Adjusts the end position of the white plate scan, in the
main scan direction. The scan begins at the start position
[as set by SP4-015-1] and extends for the specified
length.
[–3.0 ~ +6.0 / 0.0 / 0.1 mm/step]
• The total scanning length (as determined by SP2-015-1
and SP2-105-2) must be at least 2.0mm.
Sub-Scan Magnification (Scanning)101*
1 Adjusts the actual sub-scan scanning magnification. The
higher the setting, the lower the scanner motor speed.
[-0.9 ~ +0.9 / 0.0 / 0.1%/step]