Ricoh aficio 1013F - 5.1.3 INPUT CHECK (SP5-803)

USING SERVICE PROGRAM MODE
B044/B045/B046 5-24 SM
5.1.3 INPUT CHECK (SP5-803)
1. Access SP5-803.
2. Select the number that will access the switch or sensor you wish to check (see
the table below).
3. Check the status of the sensor or switch.
4. If you wish to check the signal during a copy cycle, select the required copy
mode, then press &.
5. The LCD panel will display “00H” or “01H”, as shown below.
The following table shows the meaning of the value displayed for each switch and
sensor.
Input Check Table
Reading
Number Description
00H 01H
1 DF registration sensor No paper Paper detected
3 DF original set sensor No paper Paper detected
12 Scanner HP sensor Not at home At home
13 Platen cover sensor Platen cover closed Platen cover open
15 Registration sensor No paper Paper detected
16 Exit Sensor No paper Paper detected
17 Front door switch Door closed Door open
18
Right door switch Door closed Door open
23 Mechanical counter sensing Counter not installed Counter installed
35
Paper end sensor (standard
tray)
Paper not detected. Paper detected.
44
Paper end sensor (optional
paper tray unit)
No paper Paper detected
88
Bypass paper end sensor
(100-sheet bypass)
No paper Paper detected
Input Check
Code: 0
B046M005.WMF
Input Check
Code: 0
B046M010.WMF