USING SERVICE PROGRAM MODE
SM 5-31 B044/B045/B046
Service
Tables
Program Upload (SP5-826)
NOTE: 1) Be sure to turn off the main switch before inserting or removing the
flash memory card. Installing or removing a card while the main
switch is on may damage the FCU.
2) This operation will erase any data already stored in the flash
memory card.
1. Turn off the main switch.
2. Insert the flash memory card into the card slot, with the card's "A" side facing
the front of the machine ”B” side facing the rear of the machine. (See illustration
on page 5-29.)
3. Turn on the main switch.
4. Access SP 5-826.
5. Enter "1" at the keypad, and then press OK.
6. The machine erases the card, and then writes the program into it. The "ON"
lamp flashes, and the screen counts down the progress. Uploading takes about
2
minutes. On successful completion, the screen displays "Loading completed."
NOTE: If uploading fails, the "Loading error!!!" message appears. If this occurs,
try repeating the procedure.
7. Turn off the main switch, then remove the memory card.
Display during upload:
[A]: "10" = erasing card
"11" = writing to card
[B]: Amount (bytes) remaining
to be written
Program Upload
11 : 2086914
B046M008.WMF
[A]
[B]
To Next Page
Loading...
