BIT SWITCHES
B465 5-8 SM
System Switch 00
No. FUNCTION COMMENTS
7 Amount of protocol dump data in
one protocol dump list print
operation
0: Up to the limit of the memory
area for protocol dumping
1: Last communication only
Change this bit to 1 if you want to have a
protocol dump list of the last communication
only.
How to calculate the RX level listed on the Journal (when bit 2 of system switch 00
is set to 1)
Example: 32 V34 288 L 01 00 00 00
The four-digit hexadecimal values (N) after L indicates the RX level.
The high byte is given first, followed by the low byte. Divide the decimal value of N
by -16 to get the RX level.
In this above example, the decimal value of N (=0100[H]) is 256.
So, the actual RX level is 256/-16 = -16 dB.
Communication Parameters
Mode DCS: ITU-T standard NSS: Non-standard G3
Modem rate 336: 33600 BPS 168: 16800 BPS
312: 31200 BPS 144: 14400 BPS
288: 28800 BPS 120: 12000 BPS
264: 26400 BPS 96: 9600 BPS
240: 24000 BPS 72: 7200 BPS
216: 21600 BPS 48: 4000 BPS
192: 19200 BPS 24: 2400 BPS
Resolution F: Fine, transmitted at 8 x 15.4 dots per mm
D: Detail, transmitted at 8 x 7.7 dots per mm
S: Standard, transmitted at 8 x 3.85 dots per mm
21: Standard (200 x 100 dpi)
22: Detail (200 x 200 dpi)
24: Fine (200 x 400 dpi)
Compression mode MMR: MMR compression
MR: MR compression
MH: MH compression
JBO: JBIG optional compression
JBB: JBIG standard compression
Communication mode
ECM: With ECM
NML: With no ECM
Width and reduction A4: A4 (8.3"), no reduction
I/O rate 0: 0 ms/line 10: 10 ms/line
2/: 2.5 ms/line 20: 20 ms/line
5: 5 ms/line 40: 40 ms/line
ā40ā is displayed while receiving a fax message using AI short
protocol.
To Next Page
Loading...
