BIT SWITCHES
SM 5-9 B465
Fax Unit
B465
System Switch 01
No. FUNCTION COMMENTS
0 PM call
0: Disabled 1: Enabled
This bit switch determines whether the
machine will send an Auto Service Call to the
service station when it is time for PM.
1
Auto service call
0: Disabled 1: Enabled
This bit switch determines whether the
machine will send an Auto Service Call to the
service station when a fatal error occurs.
This bit is changed to 0 (disabled)
automatically when the machine called a not
fax machine or a wrong fax machine.
Cross-reference
Communication Switch 02 bits 4 and 5 -
Wrong connection prevention method (Service
station)
2ā7 Not used Do not change these settings.
System Switch 02
No. FUNCTION COMMENTS
0 Memory file transfer
0: Disabled 1: Enabled
1: All messages in the memory (including
confidential RX messages) are sent to the
fax number that is stored as the service
station.
Always reset this bit to zero after transfer.
Cross-reference
Service station number: Function 09
1ā3 Not used Do not change these settings.
4
Automatic reset (during
communication)
0: Disabled 1: Enabled
1: The machine automatically returns to
standby mode when a page takes more
than a certain time to send (the default
setting is 60 minutes).
This timer can be adjusted with RAM
addresses 4004C0 and 4004C1.
Cross-reference
Service RAM Addresses, section 5.5.
5 Not used Do not change the setting.
6, 7
Memory read/write by RDS
Bit 7 6 Setting
0 0 Always disabled
0 1 User selectable
1 0 User selectable
1 1 Always enabled
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are
locked out, but the user can temporarily switch
RDS on to allow RDS operations to take
place. RDS will automatically be locked out
again after a certain time, which is stored in
System Switch 03 (see below). Note that if an
RDS operation takes place, RDS will not
switch off until this time limit has expired.
(1,1): At any time, an RDS system can access
the machine.
To Next Page
Loading...
