Ricoh aficio 1013F - Page 327

SERVICE RAM ADDRESSES
SM 5-55 B465
Fax Unit
B465
401400 to 4014E0(H) - NCU parameters (Refer to section 5.3 for details)
401D48(H) - Text mode selection for Fax mode 07(H): Text Sharp
0A(H): Dropout
40F1C8 to 40F3B1(H) - Dedicated tx parameters for Quick Dial 01 - 16.
There are 32 bytes for each Quick Dial. Only the 23rd to 32nd bytes are used.
40F1C8 to 40F1D1(H) - Dedicated tx parameters for Quick 01
40F1E8 to 40F1F1(H) - Dedicated tx parameters for Quick 02
40F208 to 40F211(H) - Dedicated tx parameters for Quick 03
!
40F3A8 to 40F3B1(H) - Dedicated tx parameters for Quick 16
40F3C8 to 40F9F1(H) - Dedicated tx parameters for Speed Dial #00 - #49.
There are 32 bytes for each Speed Dial. Only the 23rd to 32nd bytes are used.
40F3C8 to 40F3D1(H) - Dedicated tx parameters for Speed #00
40F3E8 to 40F3F1(H) - Dedicated tx parameters for Speed #01
40F402 to 40F411(H) - Dedicated tx parameters for Speed #02
!
40F9E8 to 40F9F1(H) - Dedicated tx parameters for Speed #49
4121DA to 4123D9(H) - Latest 64 error codes (Read only)
One error record consists of 8 bytes of data.
First error record start address - 4121DA(H)
Second error record start address - 4121E2(H)
Third error record start address - 4121F0(H)
:
64th error record start address - 4123D2(H)
The format is as follows:
1st byte - Minute (BCD)
2nd byte - Hour (BCD)
3rd byte - Day (BCD)
4th byte - Month (BCD)
5th byte - Error code : low (BCD) [If the error code is 1-23, 23 is stored here.]
6th byte - Error code : high (BCD) [If the error code is 1-23, 01 is stored here.]
7th byte - Communication line (Hex)
00(H): PSTN
02(H): PABX
8th byte - Not used
413C22 to 414469(H) - Latest 20 error communication records (Read only)
One error communication record consists of 98 bytes. The format is as follows:
1st byte - Header
Bit 0: Communication result 0: OK, 1: NG
Bit 1: Document jam 1: Occurred
Bit 2: Power down 1: Occurred
Bit 3: Character type 0: ASCII, 1: Japanese characters
Bit 4: Technical data printout instead of personal codes 0: No, 1: Yes
Bit 5: Type of technical data 0: Rx level, 1: Measure of error rate